Homeland Posted April 22, 2013 Posted April 22, 2013 Well I spoke to the head today and it looks like I am about to get the authority to order a ZD3050 and 25*7982 Ap's which will put one in each classroom and leave 3 spare to jot round other areas of the school. I know there is a lot of people on this forum that use Ruckus but I just wanted to know were you mount your ap's ?? as today I was told for best reception to the wireless devices to mount them on the ceiling as we are only a single story building, but is this where everyone else mounts them or do you wall mount them ??
Homeland Posted April 22, 2013 Author Posted April 22, 2013 I did look at the new AC access points but a couple of companies have told me to avoid them.
jamesreedersmith Posted April 22, 2013 Posted April 22, 2013 Avoid them on what basis - the access points are not even in general circulation but from what i have seen of pre-production units they are awesome! PM me if you want and we can have a chat tomorrow?
john Posted April 22, 2013 Posted April 22, 2013 My Ruckus APs are mounted on the ceiling using the mounting kit you can get from Ruckus, we do have odd ones on walls though but they are facing the direction of use
Homeland Posted April 22, 2013 Author Posted April 22, 2013 My Ruckus APs are mounted on the ceiling using the mounting kit you can get from Ruckus, we do have odd ones on walls though but they are facing the direction of use Do you notice any difference in performance with the wall mounted and ceiling mounted AP's.
Homeland Posted April 22, 2013 Author Posted April 22, 2013 PM me if you want and we can have a chat tomorrow? PM sent.
m25man Posted April 22, 2013 Posted April 22, 2013 I did look at the new AC access points but a couple of companies have told me to avoid them. No doubt you should avoid them at all costs as, 1. They are far too cheap 2. Have too little margin in the MSRP for the vendor to make any profit/commission worth the effort. 3. Do not require expensive controllers and additional licensing 4. Have no requirement for complex and expensive aftersales maintenance contracts. 5. Are simple enough to install yourself even if your IQ starts with a decimal point. No, you are far better advised to seriously look at the most expensive solutons available as they are no doubt better suited to your requirements. Or you cold spend about £50 and test one for yourself...
SYNACK Posted April 22, 2013 Posted April 22, 2013 Ruckus is fine, ceiling mounting is good as it gets you line of sight to the devices without too many meat sacks (humans) in the way to mess up the signal. Unfi is great to brute force with but lacks the civility of a managed system that can beam form, client redirect and actually pay attention to what other aps are on the channel, none of which is unfi's strong suit but if you are just flooding the area with aps effectively hitting it with a big hammer then unfit may work for you too.
m25man Posted April 23, 2013 Posted April 23, 2013 Even easier now you have your own Disty, http://www.gowifi.co.nz/
SYNACK Posted April 23, 2013 Posted April 23, 2013 Even easier now you have your own Disty, Wireless Wifi Network Gear. Buy now online! | Go Wireless NZ Ltd Don't get me wrong, I'm looking at some of their cameras and for some deployments they will work fine but some other solutions undeniably have more smarts built in. Yes some of this may be fixed by new software in UnFi's future but the others have it right now so it is unfair saying they are the same when a lot of the features don't yet exist on it. It is much better now they have released the pro grade hardware but there are still holes, these may or may not affect you but should be included in the comparisons.
Homeland Posted April 23, 2013 Author Posted April 23, 2013 Thanks guys I will take your info into my meeting at 1030 today and see what they say.
localzuk Posted April 23, 2013 Posted April 23, 2013 We mount ours according to the room their in. Some are ceiling mounted, but most are wall mounted (as our ceilings are stupidly high and difficult to cable). I'd question why you need an AP in every room though personally! That's a heck of a lot of capacity. I'd also question the need of a 3050 series controller? The 1125 would do you fine, and you can get a further license for it to move up to 50 APs and 1250 concurrent sessions.
sparkeh Posted April 23, 2013 Posted April 23, 2013 (edited) Wall mounted using the Ruckus mounting kit. As with @localzuk our ceilings are way too high to make this a sensible option. With regards to the number of APs, have you had a wireless survey done? @CPLTD came to our site and worked out how many APs we needed for our requirements and where to locate them. You might not need as many APs as you think? Edited April 23, 2013 by sparkeh 1
Homeland Posted April 23, 2013 Author Posted April 23, 2013 The school has had such bad experiences with wireless in the past so while we are not paying for it why not order the 3050 and 7982 ap's.
stevenlong1985 Posted April 23, 2013 Posted April 23, 2013 I've upgraded mine to 3050 with additional the 7982 x25 and should be arrive today. Its worked out cheaper for me than replacing the my old Zone Flex 1025 to 1125
Haptic Posted April 24, 2013 Posted April 24, 2013 http://www.edugeek.net/forums/wireless-networks/111851-independent-wifi-test.html#post956776 Just saying..... Joe 1
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now