CC3 - Network Drives not mapping

[BSG]

Hi,

 

I have just added an RM Ready workstation on a CC3 network, it has finished building however it is not mapping the drives, it says preparing connection when it oads up and has a connection as I can go Start - Run to get to the network, the mapped drives just won't show up.

 

When building this workstation it complained that the NETbios was incorrect however I knew it was, I changed it slightly I added a .Internal to it and then it went through but then all of a sudden came up that it stopped responding and needed to close, pressing don't send and then restarted and built fine.

 

Any ideas why the drives won't map?

 

Thanks.

[Michael]

The NetBIOS should be DOMAIN

The UPN Suffix should be DOMAIN.internal

[Sylv3r]

I've not got a clue why it won't map the drives, but I very rarely build direct from a CC3 ready workstation. I always do a full build even on new machines.

[BSG]

Ok I have it sorted.

 

I have been having a few embarrasing D'oh moments the past couple of weeks haha, I was logging in as just Administrator rather than systemadmin...

 

The drives are all mapped when logging on with any network account.

 

Sorry but thanks for your posts.