MattDLEA Posted February 3, 2015 Posted February 3, 2015 I have 2 a HP SE316M1 Server from @ict-direct both have 8 x 300GB SAS drives in. I need to set up a RAID. For the sake of simplicity I am wanting to install xenserver and then have 2 virtual 2012r2s running on each server. Going to be DC /DNS / DHCP and file servers. Is it best to set up RAID in the hardware? What would be the best way to do this i.e what RAID should I use? I have only seen software RAID's before like on the buffallo station where you get an error message if a disk has failed, does this happen with hardware raids two, or how would I know if there was a problem? Cheers
FragglePete Posted February 3, 2015 Posted February 3, 2015 We have ours setup with RAID1 for the 'system' on two drives (usually 15k if poss.), and the rest of the drives setup with RAID5 that houses that actual VMs. Ideally RAID6 would be better, but we've been running three servers in this config for 5 years now. Edit - you want to keep a physical DC running though. Pete
PotNoodleTech Posted February 3, 2015 Posted February 3, 2015 I'd go for 7 x 300GB SAS in RAID6 with 1 x 300GB SAS as a hot spare. You could get away with 7 x drives in RAID5 but it's not a recommended config nowadays. Never did agree with wasting 2 drives on an O/S mirror. I'd rather have the hot spare.
3s-gtech Posted February 3, 2015 Posted February 3, 2015 I have the same servers, with a similar disk array. I have two fast disks in RAID 1 for the hypervisor, 4 in RAID 10 for the guest VM OS (i.e. the C: drive) virtual disks and another 4 in RAID 10 for the guest VM storage virtual disks (i.e. the file shares etc). Works well and is fast - I don't trust RIAD 5 on any hardware.
MattDLEA Posted February 3, 2015 Author Posted February 3, 2015 Sorry for sounding a bit stupid here. So say I do 2 in a RAID 1 and the rest in a RAID 6 or 10 id then install xenserver on the RAID 1 and then from there use the RAID 6/10 AS the storage for 2012 thats installed via Xenserver? Is that how it works?
3s-gtech Posted February 3, 2015 Posted February 3, 2015 My layout involved three arrays - hypervisor, VM OS, VM storage, simply to separate the job each set of spindles did (so heavy OS work didn't affect file storage). You can't do that in RAID 1-RAID 10-RAID 10 with 8 disks, but you could do RAID 1-RAID 5-RAID 5 or RAID 1 (two disks)-RAID 10(six disks). You can even share the array the hypervisor is on with the VM OSs, if it's big enough, as the hypervisor doesn't tend to do that much once booted.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now