Help for reset AD, DNS, DHCP...HELP!

[macsit]

Is there a way to reset roles with single click? Do I have to remove the each then reinstall?

 

My all nodes are in a temp dhcp ip range;

 

*.*.*.101 to *.*.*.199

 

After the reset or reinstall, what's the proper way to setup the dhcp to this;

 

*.*.*.30 to *.*.*.100 for DHCP

 

*.*.*.2 to *.*.*.29 for STATIC

 

Thanks in advanced.

[DEvans]

I think it depends on your server operating system. In server 2003, whatever you set in DHCP is law and cannot be changed unless you remove and redo.

 

I think in Server 2008R2 you can modify your DHCP and then just authorised the new scope. Though I have never done this before.

 

Generally what you want to do, trying to stick to your examples is set up DHCP with a scope that covers your entire range. e.g.

 

*.*.*.2 - *.*.*.100

 

And set in exclusions within that range for your statics *.*.*.2 to *.*.*.29 The left over then will be your DHCP scope.

[macsit]

I deiced to remove all of the roles and start over. Does anyone in here know a good link with installation procedure with screenshot?

[Domino]

Here's a Dcpromo runthrough: How to setup a Microsoft Windows 2008 R2 Domain Controller | Sysadmin Tutorials

 

DNS: Install a DNS server in Windows Server 2008 - Windows Server - Techguide

 

DHCP: How to Install and Configure Windows Server 2008 DHCP Server

 

Of course these do all depend on what your existing infrastructure is like, but should give you an idea of a starting off point

[macsit]

Thanks Domino.

 

Those helps.

 

Here's a Dcpromo runthrough: How to setup a Microsoft Windows 2008 R2 Domain Controller | Sysadmin Tutorials

 

DNS: Install a DNS server in Windows Server 2008 - Windows Server - Techguide

 

DHCP: How to Install and Configure Windows Server 2008 DHCP Server

 

Of course these do all depend on what your existing infrastructure is like, but should give you an idea of a starting off point

[macsit]

Got this error message after DHCP installed;

 

Attempt to configure DHCP server failed with error code 0x80074e54. The scope parameters are incorrect. Either the scope already exists or its subnet address and mask is inconsistent with the subnet address and mask of an existing scope.

 

What should I do?

 

Thanks again.