ronanian Posted November 18, 2011 Posted November 18, 2011 I have a growing population of XBox users who want to use XBox Live. They are all on my network sharing a single internet-facing IP address in a standard many-to-one NAT setup. The XBox tests their connectivity and gives it a rating of "Strict NAT". It recommends port numbers that I should "open". I have checked and those ports are not blocked by the firewall. The next step would be port forwarding, but obviously I could only do that for one lucky user. It also recommends enabling UPnP, but Sonicwall does not support UPnP. I doubt UPnP would work in a shared environment even if they did. Research indicates that my Sonicwall NSA4500 simply will not support it no matter what I do. At best I could buy enough internet-facing IP addresses to give each of them one-to-one NAT and even then they'd only get up to a rating of "Moderate NAT". Does anyone here have a similar configuration, either with a Sonicwall firewall or a different brand?
featured_spectre Posted November 18, 2011 Posted November 18, 2011 You may need to check the ports are open in the modem as well as the router. I use a SonicWall router at home (well the mrs does for work) and it is not an issue when I use her work connection.
mattx Posted November 19, 2011 Posted November 19, 2011 Can't you forward the ports to the actual sonicwall itself thus everyone getting the beneifit ?
featured_spectre Posted November 19, 2011 Posted November 19, 2011 The sonic wall can't handle it well.
mattx Posted November 19, 2011 Posted November 19, 2011 The sonic wall can't handle it well. Chirst, sounds like a pile of poo if it can't do that !!
featured_spectre Posted November 19, 2011 Posted November 19, 2011 Well it can handle it, just not as well as other devices. It's literally a hardware firewall with minimal configs available.
ronanian Posted November 21, 2011 Author Posted November 21, 2011 There is no "modem" as such on our T3 and our 100Mb fiber lines. They do not block any ports. The Sonicwall is the internet-facing front end with all of our IPs on it and port-forwarded to our servers as needed. The Sonicwall NSA4500 is an enterprise-class hardware firewall with thousands of configuration options...if it was simple like a home router then this would probably be easier. I was hoping that someone else here supplies internet access to resident students and has dealt with a similar issue. I have hundreds of students and only a few IPs so I can't use port forwarding.
Willott Posted November 21, 2011 Posted November 21, 2011 There are mentions on a number of sites about port triggering rather than forwarding (I think it somehow does dynamic port forwarding based on port triggers). May be something to look at as it's suggested to work (on support.xbox.com for one site)
ronanian Posted December 14, 2011 Author Posted December 14, 2011 Update: I was able to get my users a "Moderate NAT" rating. On the Firewall > VoIP Settings page in SonicOS Standard or VoIP > Settings in SonicOS Enhanced, enable "Consistent NAT". Whatever this VoIP function is, it somehow helps with XBL's NAT rating. I found it buried in a couple Sonicwall forum threads on the issue, although it's also in this KB article: https://www.fuzeqna.com/sonicwallkb/consumer/kbdetail.asp?kbid=3956 ...of course, one gets turned off to that KB article pretty quickly when reading most of the steps which are about assigning an address to the xBox and port-forwarding to it, which doesn't work when you have dozens or hundreds of XBL users and only a few Internet-facing IP addresses. If it didn't have that stuff I might have noticed the one step about "Consistent NAT".
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now