Reloading an entire stack?

[talksr]

Hi there,

 

Does anyone know if there is a CLI command for HP switches which will enable me to reboot an entire stack?

We have a stack consisting of 8 separate switches?

 

I have tried running an SSH session to the controller and running the "reload" command, but this only seems to bounce the commander, not the entire stack.

 

Any ideas would be greatly appreciated!

[Davit2005]

To be honest, I'd do through the Web Gui and it is the only thing I do through the web gui, If it for a firmware upgrade. As you want to make sure the whole stack restarts, prob the safest way.

[njc235]

Which model switches e.g Procurve or Comware?

[talksr]

Which model switches e.g Procurve or Comware?

 

All Procurve, a number of models:

 

J9280A

J9777A

J9087A

J9775A

[Sibrows]

I believe your looking for the 'reload' command.

 

But based on the title of your post you may have already found this and it isn't working?

Edited September 5, 2016 by Sibrows

[njc235]

These are not stacking switches.

[talksr]

I believe your looking for the 'reload' command.

 

But based on the title of your post you may have already found this and it isn't working?

 

Thank you. Yup, if I do reload, it just does it for the switch I am on, which is usually the commanding switch.

 

- - - Updated - - -

 

These are not stacking switches.

 

Oh????

[njc235]

Hi, sorry I meant a proper IRF stack or stack via stacking modules. You could try the 'reload system' command. I will ask one of our engineers next time one's here.