Second Hand Smartboard and Unifi 35

[Simcfc73]

Hi,

 

Due to us being super skint I took a punt on a projector and SB off Ebay. The Smartboard seems to work fine with no dead spots but the light and the buttons on the projector don't work... there was also a 3rd party remote control which doesn 't respond.

 

I am used to using normal projectors and not used to this model....it comes with the leads to switch it on and off which works fine and it comes on with that. Problem is I am not sure how to wire it up... when I switch it on it says no smartboard is attached...which goes away if I connect to the usb on the right but then where do you connect your computer to???

 

Also, can the settings be changed from the network or I that just for connecting to a remote PC?

 

I can use the SB to change the settings using the touch screen but its limited... Its 99% working and don't want to send it back if its almost right.

[network41]

Might be worth looking at this to ensure you have all the parts you need :

 

Step 3 Connecting the Cables

[Simcfc73]

I have all these cables, the last bit shows a USB being plugged in and going to the right, doesn't show how the SB is connected to it though.

[network41]

Will need to go and have a look at one of ours , I think the cable that runs down the right hand side connects back via USB to the Grey block but will have a look

[network41]

Sorry I'm talking rubbish. Went and looked at our board. The USB cable that runs down the right hand side behind the SB connects to the USB connector on the SB. The PC connects via USB to the grey block, hope this helps.

[Simcfc73]

Many thanks, really house I can use it with no remote.