Geoff Posted June 26, 2007 Posted June 26, 2007 Anyone know where I can get them? Or how much they cost?
Andrew_C Posted June 26, 2007 Posted June 26, 2007 I'm sure that a generic CPC unit will do the job. All we need to know is:- Voltage, Current, connector size and polarity. And probably <£5.00
plexer Posted June 26, 2007 Posted June 26, 2007 Geoff: PM me your address and I'll post you one of my spare ones mate. Ben
witch Posted June 26, 2007 Posted June 26, 2007 I couldn't get any from anywhere so I ended up buying them from promethean If anyone knows where I can get cheaper ones that will fit, PLEASE let me know!
Ste_Harve Posted June 26, 2007 Posted June 26, 2007 The Promethean PSU output 6v and 1.7a. I can't remember if the centre is positive or not. And i can't tell the size of the connector.
ConTheITGuy Posted June 26, 2007 Posted June 26, 2007 Would you mind mentioning how much they were Witch? Just out of interest. Replacement projector remotes were £75!! Pens have come down quite a bit now, especially if you buy a few. Andy
Ste_Harve Posted June 26, 2007 Posted June 26, 2007 I paid 25 quid for 1. I think thats the price they are unless people can get them cheaper?
Andrew_C Posted June 26, 2007 Posted June 26, 2007 CPC code PW00521 is a 6V 2A PSU with a range of connector sizes, £13.11 ex VAT. Page 1600 of the dead tree catalogue. The relatively high current and 6 rather than 12 volt pushes the cost up.
StuartC Posted June 28, 2007 Posted June 28, 2007 http://cpc.farnell.com/jsp/Batteries+&+Power+Supplies/AC+to+DC/FRIWO/1812117/displayProduct.jsp?sku=PW01412 this is very close to the psus for Activboards (same company, unbranded etc), but don't order it because the output voltage is too high and the amps are off too, but it's a good example because these are £20 without packaging. Ours are £25+£5 P&P. That's not bad when you compare to some companies.
Andrew_C Posted June 28, 2007 Posted June 28, 2007 this is very close to the psus for Activboards (same company, unbranded etc), but don't order it because the output voltage is too high and the amps are off too,... and two posts up, I link to one with enough current and not too many volts, and it's cheaper too!
StuartC Posted June 28, 2007 Posted June 28, 2007 up to you, I know how sensitive the chips on our electronics are, and I wouldnt risk it. definately not with a board that's in warranty. if it's in warranty and we see another kind of psu dangling from the system during a repair then there may be a hefty bill involved.
CyberNerd Posted June 28, 2007 Posted June 28, 2007 I'm with Andrew_C : I've used the 6V 2A £13 PSU's from CPC and there fine. (actually I tested it on a board that was in warranty - just to be sure A 2A PSU is rated to be able to provide 2 Amps - if the board only draws 1.8 amp then it's not going to force 2A on it!. Just another over hiked price from promethean.
Andrew_C Posted June 28, 2007 Posted June 28, 2007 up to you, I know how sensitive the chips on our electronics are, and I wouldnt risk it. Makes mental note...
Ric_ Posted June 28, 2007 Posted June 28, 2007 @StuartC: Surely if a board is in warranty, the PSU would be under warranty and would simply be swapped out by you guys?
steve Posted June 28, 2007 Posted June 28, 2007 I thought the same myself ric_ after suffering a psu failure, I contacted promethean. The 10 year warranty only covers the actual board, not the pens, psu or cables. Considering the price of the boards, I felt a little short changed.
Ric_ Posted June 28, 2007 Posted June 28, 2007 @steve: I could understand the likes of pens and maybe connection cables not being covered since these are open to abuse (e.g. dropping pens and continual plugging/unplugging). Surely a PSU should last the life of the board though (unless there is a power surge or something and then you would not expect a warranty replacement).
steve Posted June 28, 2007 Posted June 28, 2007 @steve: I could understand the likes of pens and maybe connection cables not being covered since these are open to abuse (e.g. dropping pens and continual plugging/unplugging). I agree. Maybe its time promethean did some more market research and developed products more friendly to the consumer. I for one would buy lots of nice new robust pens / power supplies from promethean if they provided a good TCO.
Ric_ Posted June 28, 2007 Posted June 28, 2007 @steve: To be fair, a 10 year warranty on the board is very good. However, I would argue that is the least likely part to fail. Personally, I use GTCO Calcomp Interwrite boards. These come with a 2 year warranty which covers the board, pens (you get two) and the PSU. I'm not sure about the cables since the warranty statement neither mentions that they are or are not covered but I think I could probably afford to replace this since they are standard USB cables rather than the funny-looking efforts that Promethean use.
webman Posted June 28, 2007 Posted June 28, 2007 In my opinion the pens could have slightly more weight to them and have a rubberised grip as has been suggested here.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now