DSapseid Posted September 22, 2009 Posted September 22, 2009 I have 2 of the c-Class GbE2c Switches in my C3000 blade enclosure and one of them is working fine but i am now experiencing some issues where the one isnt providing enough bandwidth for all the servers so i am going to utilise the second one and configure port trunking but i cant get the ports to enable on the second switch!! I have tried via telnet into the console and also via the web browser but i get the following error: "ERROR: Server Port 1 cannot be enabled because of a mismatch" I have updated the firmware on this switch to 2.0.60 from 2.0.50 to see if it helped but it didnt. Any ideas?? Cheers Dan
BaccyNet Posted September 27, 2009 Posted September 27, 2009 I cant offer much advice as I cant remeber how ours were setup (plus I'm not near it atm) Are you configuring it through web interface or through telnet? Do your On-Board Administrator(s) detect both switches correctly?
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now