Alis_Klar Posted September 16, 2019 Posted September 16, 2019 Seems silly but a board was taken off the wall by painters and I can't figure out out to wire it up again as there are several unmarked power and usb ports at points all over the board and frame (for projector) Do you have a PDF of the installation instructions for this board with frame that I can use to wire it up again?
Alis_Klar Posted September 16, 2019 Author Posted September 16, 2019 It's the frame for the PRM35 projector. Found this PDF but its not detailed enough on page 18 for the wiring. https://www1.support.prometheanworld.com/fr/files/public/pdfs/TP-1845-V04.pdf
Alis_Klar Posted September 16, 2019 Author Posted September 16, 2019 Think i've answered my own question. Connection Guide is here https://support.prometheanworld.com/article/1328 but its not all that clear!!
Alis_Klar Posted September 16, 2019 Author Posted September 16, 2019 (edited) Still confused. On my board the USB from the PC plugs into the outside of the frame but in the diagram the USB input is directly into the ActivBoard electronics. Does the ActivBoard electronics act as a USB hub and that is why there are 2 outputs from it? Edited September 16, 2019 by Alis_Klar
Boredguy Posted September 16, 2019 Posted September 16, 2019 On ours, we have the USB cable going from PC directly up to the bottom USB Input on the top panel on the board. The 2 USB amplifier/Aux cables are then plugged into the inner edge of the board just like the image. Same with the power cable to connect up the amplifier for the built in speakers.
Joanne Posted September 16, 2019 Posted September 16, 2019 Yeah, essentially it's a hub, so whatever side you are using needs the cables to go to that side.
DangPro Posted September 16, 2019 Posted September 16, 2019 If you are just wiring up for the computer then this would be the document you can use. https://support.prometheanworld.com/wp-content/uploads/dlm_uploads/TP-1741.pdf You will find around page 25 a simple diagram.
Alis_Klar Posted September 16, 2019 Author Posted September 16, 2019 This one? Yeah I think I can do it now. Thanks all. If you are just wiring up for the computer then this would be the document you can use. https://support.prometheanworld.com/wp-content/uploads/dlm_uploads/TP-1741.pdf You will find around page 25 a simple diagram.
Recommended Posts