iSteve

We've had good results over a number of years with BenQ RE65xx interactive displays.

I've passed on some feedback. Unfortunately with recent incidents there doesn't seem to be a perfect solution. We've upgraded standard duty mags to heavy duty ones to reduce doors being forced, but as you say, if they are attached to cheap MDF frames then the frame fails.

We have several Paxton PaxLock Pro handles installed across our sites and have experienced repeated failures. In some cases, students have been able to damage the handles relatively easily. For example, a set fitted to a pastoral office door has failed three times after students repeatedly jiggled the handle in frustration, resulting in a “handle stuck” error. On inspection, the internal mechanism was found to be damaged each time. The Paxton marketing describes the handles as ultra-reliable and suitable for high-traffic environments such as schools and commercial buildings. This doesn't seem to the the case. Are other schools using these handles, and if so, have you experienced similar issues?

Our solution with guidance from Axis, was that motion detection was killing our performance. We had 120 cameras all recording via motion trigger. Once we set the cameras to record continuously during school hours, and switch to motion out of hours, the problems went away. We are now up to 143 cameras on one server, and everything is fine.

D'oh...you can...it's been a long week

I have one test AP added, by IP. You can't add a subnet in this section.

Hi all, I am blundering my way through trying to set up NPS / RADIUS with Unifi APs. So far: NPS feature installed on Server 2022. Server is registered with AD. Basic policy is set up to allow users in certain groups to authenticate. Unifi has Captive Portal set up on my BYOD VLAN. A profile has been made, pointing to my NPS server for auth On my Windows 11 client, I can see my BYOD WLAN. The laptop connects, opens a browser but then can't do anything else. A prompt to authenticate does not appear. One thing I am not clear on, is on the NPS server, when adding a RADUIS Client, is do I add the Unifi controller or all APs? Would be very glad for any advice on this from those who might have done it!

Hello - we seem to have references to 8.4 and 8.7 on a user profile, so 8.8 may work if you are happy to share - thank you!

Hello, This may be the wrong category for this post.... We are missing our installer for Priva Top Control - this is used to manage boilers from a PC over the network. The company that provide it say that the software was phased out in 2021. Does anyone have an installer for of TC Operator / Top Control that they could send to me? TIA

The sensor display allows you to select Response Time or Downtime only.

Hello, We have an APC NetBotz 570 temp sensor and have imported a MIB in to PRTG so that PRTG can monitor the NetBotz 570. PRTG can 'see' the temperature sensor, however in the main PRTG window it displays the sensor's scan time, rather than the temperature value. Is there a way to configure PRTG to display the temperature value without having to go in to the specific sensor in order to see it?

Yep - we've done it within 2 minutes of power up. It may be that the reader we are trying is not 'second generation'...

Hello - is this the 'silent operation' check box, as that seems to have no effect at all, unless it requires the ACU to be reinstated or something like that?

Hi All, Have any of you successfully silenced the beep on a Paxton door card reader? We have a silence card which you are supposed to present to the reader to turn the beep off but it is still beeping on every card read. The spec sheet says it's for 'next generation' readers, but we don't know if our Mifare door readers are, or not. Any ideas? Stephen

This sounds similar to our experience. We're hoping that splitting the load between two machines will help but am not clear on the process