[sccm 2012] 1.WinPE driver for Lenovo desktops m55e (9637-cto) Nic

[elit]

As the title says really.
 
We have almost deployed our entire network using SCCM2012 however we have a couple Lenovo desktops m55e (9637-cto) on site and they use a Broadcom - Network - NetLink ™ Gigabit Ethernetfamily NIC, and I can't find a driver to enable me to image them. I am wondering if anyone has had this problem and found an answer.
 
 
many thanks

[Arthur]

Have you tried the NetLink driver for Windows Vista from Broadcom's website?

 

Assuming your NIC is a BCM5786 (PCI\VEN_14E4&DEV_169A) that driver should work.

[elit]

Have you tried the NetLink driver for Windows Vista from Broadcom's website?

 

Assuming your NIC is a BCM5786 (PCI\VEN_14E4&DEV_169A) that driver should work.

 

 

 

I have performed testing manually through F8 to load the driver I downloaded from the site of Bordcom no success, with the command drvload b57nd60x.inf (32bit and 64bit)

It registered successfully, but ipconfig shows no network address

[Arthur]

It registered successfully, but ipconfig shows no network address

Are you able to get an IP address after running wpeutil initializenetwork? Are there any other drivers that may be interfering with the BCM5786 driver?

[elit]

i try wpeutil initializenetwork that succeeded

Still no network writes

 

I would like to indicate that I am using the PE version of Windows 8 6.2.9200

And were able to install other driver works through manually through the command drvload b57win32.inf

But not via PXE

 

 

thanks

[Jeremym87]

Did anyone have a fix for this? I have a ton of 9637, and I'm unable to get a driver to work with the SCCM 2012 SP1 Boot image.

[MichaelDK]

Jeremym87> Did you find a solution - have same problem as you...