3D Printing Services - recommendations?

[Ditto]

Would anyone be able to recommend a 3D printing service company. I need to get a batch of 24, 6cm diameter 'rings' to overcome a GU10 light challenge. I had previously been recommended 3d London 3D printing but recent trust pilot reviews aren't great. I'm awaiting a quote from 3DPrintWorks that have better recent trust pilot reviews. I don't have school access 3D printing, but I need high quality finish so I am hoping a commercial printer is the best route. If anyone has used anyone else and would recommend (or not!), I would be keen to hear.

[Davit2005]

Would anyone be able to recommend a 3D printing service company. I need to get a batch of 24, 6cm diameter 'rings' to overcome a GU10 light challenge. I had previously been recommended 3d London 3D printing but recent trust pilot reviews aren't great. I'm awaiting a quote from 3DPrintWorks that have better recent trust pilot reviews. I don't have school access 3D printing, but I need high quality finish so I am hoping a commercial printer is the best route. If anyone has used anyone else and would recommend (or not!), I would be keen to hear.

 

I've used GoPrint3d but just the once, they were very helpful. I only had requirement for a one off order of 4 brackets (about 25mm x 25mm x 75mm) but the service was good.

 

https://www.goprint3d.co.uk/3d-printing-service/

[Ditto]

I've used GoPrint3d but just the once, they were very helpful. I only had requirement for a one off order of 4 brackets (about 25mm x 25mm x 75mm) but the service was good.

 

https://www.goprint3d.co.uk/3d-printing-service/

 

Thanks - I've sent off for a quote. 3DPrintWorks has come back at £6 each + 10 P&P, which for a run of 12 or 24 is a too steep for me! 3D London were nearer £2 each, so might have to take a chance in spite of recent Trust pilot reviews.