Csco command to view the VLAN configuration

[genesis]

HI

 

 

I have CISCO POE Edge switches and there are different VLANS set up by my predecessors on this switch.

 

I have two vlans ie VLAN92 and VLAN 93

 

When a devices is connected to VLAN 92 the wireless is working and when device is connected to VLAN 93 wireless is not working(The device is not getting the IP address from the DHCP server)

 

 

I would like to compare the configuration of the working VLAN with the non working VLAN

Please let me know the cisco command to view the VLAN configuration of VLAN 93

 

Thanks

Edited August 31, 2018 by genesis

[FN-GM]

For layer 3 VLANS

 

 

Show run int vlan xx

 

 

For Layer 2 VLANS

 

 

Show Vlan

 

 

Note: You can have L2 and 3 on the switch at the same time.

 

 

Although what you describe might not be the direct VLAN configuration. There might be pruning set-up on the uplinks blocking traffic from certain VLANS.

Edited August 31, 2018 by FN-GM

[genesis]

Show VLAn gives the following information.

SW-02-03#show vlan

 

lists all the Vlan

VLAN Name Status Ports

---- -------------------------------- --------- -------------------------------

1 default active Gi1/0/25, Gi1/0/26, Gi1/0/27

Gi1/0/28

92 Guest active

93 VLAN0093 active

 

What is the command to see configuration of the VLAN 93

[FN-GM]

If it is a layer 2 VLAN that is everything. Did you run the Layer 3 command?

 

I would have a look at the port config of your uplinks and the ports your devices connect to.