Routing for VLAN on HP Procuve

[trannghia]

Hi All,

Now, I'm using the sw HP 2610-48 and have created 3 vlan on it.

- Default VLAN IP: 192.168.30.10 MS: 255.255.255.0

- VLAN 10 IP: 192.168.10.10 SM: 255.255.255.0

- VLAN 20 IP: 192.168.20.10 SM: 255.255.255.0

- DHCP Server IP: 192.168.30.7, created 3 scopes for 3 vlans and all the computers on each the vlan can be get the IP from the DHCP server.

- Firewall IP: 192.168.30.2 SM: 255.255.255.0

 

The problems:

I have inter-vlan routing turned on, each vlan is able to ping each other. But, only the devices connected to the default-vlan is able to ping the firewall and get onto the internet, VLAN 10, 20 cannot ping to the gateway and go to the internet.

I thinks the problems from my routing table. But, i don't know how to fix it.

Please help.

 

Switch configuration:

 

; J9088A Configuration Editor; Created on release #R.11.112

hostname "VLAN" 
ip default-gateway 192.168.30.2 
ip routing 
snmp-server community "public" Unrestricted 
vlan 1 
  name "DEFAULT_VLAN" 
  untagged 25-52 
  ip address 192.168.30.10 255.255.255.0 
  no untagged 1-24 
  exit 
vlan 10 
  name "VLAN_10" 
  untagged 1-12 
  ip address 192.168.10.10 255.255.255.0 
  ip helper-address 192.168.30.7 
  exit 
vlan 20 
  name "VLAN_20" 
  untagged 13-24 
  ip address 192.168.20.10 255.255.255.0 
  ip helper-address 192.168.30.7 
  exit 
ip route 0.0.0.0 0.0.0.0 192.168.30.2 

 

Edited December 10, 2015 by trannghia

[Davit2005]

You look good, have you put an ip route from the firewall back to the vLANS via the Switch 0 ????

 

i.e. 192.168.10.0 255.255.255.0 192.168.30.10

[trannghia]

You look good, have you put an ip route from the firewall back to the vLANS via the Switch 0 ????

 

i.e. 192.168.10.0 255.255.255.0 192.168.30.10

 

Thanks @Davit2005.

It has done .

Last time, i config incorrect ip route on my firewall that why i cannot go to the internet .

[Davit2005]

Thanks @Davit2005.

It has done .

Last time, i config incorrect ip route on my firewall that why i cannot go to the internet .

 

No problem

[Julian]

Please get your switch to print out its routing table, by from telnet command line doing "show ip route". This should help see where packets are being directed.