hojokolo

Thanks again @tri_94 I connected by mistake the gold leg to red wire. [ATTACH=CONFIG]38579[/ATTACH] Will that be a problem? I switched on the projector and the lamp stays on (while the mirror-door stays open). It seems that I just saved about 140€ thanks to you and the forum! Thank you all very much again!

I did find the manual but I can't figure out the amp/volts values you mention. The only relevant thing I did find is in page 14, where there is a photo and next to the motor connector you can read "EW01". Manual: https://www.dropbox.com/s/076yrl1rzeyjxi3/hitachi_cp-a100_ed-a100_ed-a110_sm.pdf?dl=0 and https://www.sendspace.com/file/e5r0fq Can you please be more specific about which led or resistor I should try? Thanks in advance EDIT: I found this tutorial in dutch (I think) In page 4 there is this: Soldeer nu een lampje ( 12v-0,1A) aan het kabeltje en plug het stekkertje weer aan de printplaat Which I think means that I have to try out a 12v-0,1A LED. What type of connector should I buy? I will try this tomorow and I will let you know. Tutorial: https://www.sendspace.com/file/dekge3