Replacing a Promethean PRM-10 projector

[Jobos]

We've got a Promethean +2 board with a orange PRM-10 projector which is now in need of replacement. What projector would fit this board please?

[kevin_lane]

What's wrong with it

[Jobos]

What's wrong with it

It's just getting old and dim. It had a lamp change last year but I don't think it will last another year so I'm planning to replace it this summer.

[achedgy]

Got the same issue with one of these, can't find a replacement either. Got a nasty feeling it's going to be a bit more expensive than i hoped! These all in one solutions are great until something needs replacing!

[Jamman960]

I replaced one with an Epson PLC-WL2500, needed the mount replacing. It wasn't too bad as it was one of the original +2's with the round pole rather than the newer square type.

[broc]

A couple of months ago we bought a PRM30 projector and an adapter mount for the arm. Simple swap over. If I recall correctly, it was under £600 for both. Ours was for the original round tube arm, I understand you can get different adapters according to the arm vintage. Edited April 20, 2012 by broc

[Marc-Engineer]

Quite right Broc at the moment units are still available with adaptor to fit these, available from whoever provided it originaly, but bare in mind Sanyo has now stopped production of all projectors after the company ceased in a buyout from Panasonic.

 

Marc

Projector Engineer