Moving server to new office premises

[Sonic007]

Hi.

 

I’m moving my server to a new office that has its own internet and ports round the office.

I’ve got the settings from doing an ipconfig.

 

What do I need to update on my server to get it to work?

I’ve got the physical machine connecting fine but my hyperV DC won’t connect.

 

I’m confused on where I need to update the gateway settings or in the hyperV virtual switch?

 

Any help much appreciated.

 

 

Thankyou.

[Jcx500]

I think the hyper v switch is listed in the adapters part of network settings in control panel

[Sonic007]

The problem I have is the host is connected via dhcp and the hyperV domain controller is on a different ip range and gateway.

[Jcx500]

Is there any switches at the new location ?

[Sonic007]

Yes there are basic switches.

 

The issue is the domain controller was setup on a 192 network with a bt router on same ip range, subnet mask and gateway

Now the offices own internet is on a 10.4 up range.

 

I have my NIC on the phisical machine getting dhcp off the offices wall port. In hyperV I have a virtual switch that uses that network card but of course it won’t work as the Virtual domain controllers ip settings are on a different subnet.

[Jcx500]

Is there multiple ports on the host , if so couldn’t you use a bridge port ? Or setup Up routing and remote access on the DC to do NAT between the two networks

[Sonic007]

Thanks for your reply. There is a second port on the host. I guess I could’ve used that.

In the end have got a spare edge router I’m going to put in and configure it for the ip range.