Anyone seen one of these Pentagonal heads?

[fiza]

Trying to remove the cage around our Hall Projector to replace the lamp.

The screws holding the cage onto the mounting are pentagon shaped with a pin.

Anyone know where I can get the proper screwdriver bit to undo these please?

 

[headoned]

We had the same ones on one of our projector cages. I'm pretty sure we ended up using these

https://www.amazon.co.uk/Draper-71394-4-inch-Square-Sockets/dp/B00023TA10

[synaesthesia]

Dealt with those before too. Didn't get as posh as using security torx bits but did get as far as finding a flat blade driver that fitted well enough to circumvent the noggin

[sat_s]

We had a similar issue with a hexagon security bolt. Probrand couldn't help but advised on this https://www.accu.co.uk/en/666-security-hexagon-key-wrench They maybe able to supply you a pentagon key

[fiza]

We had the same ones on one of our projector cages. I'm pretty sure we ended up using these

https://www.amazon.co.uk/Draper-71394-4-inch-Square-Sockets/dp/B00023TA10

 

Ordered using Prime so hopefully can try it again tomorrow.

 

Thanks