Imaging 8.1 issues with MDT 2013

[itdirectorscut]

HI!

 

After not getting far with Windows 10 start menu, I have gone back to 8.1 (only 25 units) I can take off an image using MDT 2013 (this is completely up to date as for windows 10) all good, I create a task and make sure it take 100% of the disk (they are only 32Gb) add the newly captured image and all good.

 

I kick off the the imaging process, it brings down the image and gets to apply image reboots and then I see this Windows error:

 

Windows could not complete the installations. To install windows on this computer, restart installation.

 

Looking around this could affect even normal installs, I check the size of the C: drive and it states 5,103,626 bytes free, now im a little rusty on this after only dealing in gigabytes and terabytes for many years but that is 5Mb????

 

Im lost at the moment and im sure its a real easy and obvious fix but after looking so hard I think I have gone to deep and need to pull back lol

 

Thanks!!

 

Steve

[sted]

are you saying you make the c drive take 100% of the 32gb drive or the install image is 32gb?

 

windows creates extra small partitions for booting iirc it dosent boot of the c drive anymore but a smaller boot partition

[itdirectorscut]

HI!

 

Yes I set it to take 100% of the C drive (32Gb SSD) no recovery partition and the image is around 15Gb, the reason I set it to 100% is that was the only way I could image Windows 10 (which I have aborted).

 

TIA!

 

 

are you saying you make the c drive take 100% of the 32gb drive or the install image is 32gb?

 

windows creates extra small partitions for booting iirc it dosent boot of the c drive anymore but a smaller boot partition