Jump to content

Recommended Posts

Posted

Hi guys, wonder if anyone can help.

I am replacing an ancient Cisco switch with a HP ProCurve 2920

I have done most of the config but struggling with the differing proprietary commands for a few of the settings on the HP.

 

I have just 2 vlans setup and need to replicate the below config on the new HP switch (have grabbed the section of config from the existing Cisco switch):

 

spanning-tree mode pvst

no spanning-tree optimize bpdu transmission

spanning-tree extend system-id

!

!

!

!

interface FastEthernet0/1

switchport access vlan 2

no cdp enable

!

interface FastEthernet0/2

switchport access vlan 2

no cdp enable

!

interface FastEthernet0/3

switchport access vlan 2

no cdp enable

!

interface FastEthernet0/4

switchport access vlan 2

no cdp enable

!

interface FastEthernet0/5

switchport access vlan 2

switchport trunk native vlan 2

switchport trunk allowed vlan 1,2,1002-1005

switchport mode trunk

no cdp enable

spanning-tree portfast

!

interface FastEthernet0/6

switchport access vlan 2

switchport trunk native vlan 2

switchport trunk allowed vlan 1,2,1002-1005

switchport mode trunk

no cdp enable

spanning-tree portfast

!

interface FastEthernet0/7

switchport access vlan 2

switchport trunk native vlan 2

switchport trunk allowed vlan 1,2,1002-1005

switchport mode trunk

no cdp enable

spanning-tree portfast

!

interface FastEthernet0/8

switchport access vlan 2

switchport trunk native vlan 2

switchport trunk allowed vlan 1,2,1002-1005

switchport mode trunk

no cdp enable

spanning-tree portfast

 

Many thanks

Posted
If you would like an HP example file and you could adapt it to suit, please get in touch tomorrow and I'll happily send one over

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



×
×
  • Create New...