Halo here Victor from Germany.
We just received this machine at the Univ Leipzig.
I would really aprreciate if can send me some of the drivers / software to start using it, as we just got the naked device.
I was thinking if might be possible to use this device under Linuxcnc, or some of you have some experience / knowledge on this.
I'm guessing that the USB might be just a USB to parallel port adapter, connected by the white flat cable.
I have some photos of the 3 boads on the back.
If this is true we could make the configuration much easier.
Thank you very much for your time!
/v
