Skyper

Hitachi cog.stp TW-35T-M1.stl

Depends on which cog is broken, most likely its the small one in the mirrors cylinder, if so you only need to dismantle the bottom screws to remove the top shield and then you can already remove the cylinder shield to get to the cog. If however it's one of the cogs in the cog series, you have to remove about 50 screws... I did both without breaking the thing, just take your time

You got mail!

i got a .stl file for that one also, send me a pm and I will mail it to you

Yep got an stl file, pm me your mail and i will send it to you!

Same problem over here, I managed to 3d print one of the cogs (35 teeth one) but still isnt working, I think the small one on the mirror was also broken, opening it up again now