omardaiekh
-
Posts
3 -
Joined
-
Last visited
About omardaiekh
-
but if light is coming out of it for 1 second. then its not the heat thing. when the trigger is triggered , it wont start up at all. the power red light will get green for 10 to 15 seconds without any light coming out of the projector. then it gets back as if you shutdown it. and the power red light keep blinking. so i dont know what the problem with yours. sorry. regards
-
Sanyo PLC XE-40 1-first you need to take off the screws shown in picture 1.(7 screws). 2-pull over the upper case half. 3-as shown is the other 2 pictures try to insert something that is hard and narrow until you feel the tick (this tick means that you reset the heat trigger to its original case). so the projector can work normally now. regards
-
can we have a guide for xe40 pleaseeeeeeeeeeeeeeeeeeee
