Ric_ Posted November 30, 2006 Posted November 30, 2006 I have an Adaptec 29160 SCSI card which I use to connect my Tandberg LTO2 StorageLoader. The card has stopped recognising the existance of the both the backup drive and loader!!! The card does not even see the devices at boot time (despite obviously sending some kind of signal to the devies because you can hear them resetting). Is there any sort of diagnostic I can run on the card before having to shell out nearly £200 for a new one?
Ric_ Posted November 30, 2006 Author Posted November 30, 2006 I have removed and re-attached the terminator and noticed that the little green LED illuminates when the terminator is connector. This does not seem to have had any effect though Any other ideas?
djm968 Posted November 30, 2006 Posted November 30, 2006 What hardware is the adapter installed in? Most branded server manufacturers offer reasonable good SCSI diagnostics from a diagnostic partition. Just a thought
Ric_ Posted November 30, 2006 Author Posted November 30, 2006 OK... tried to post before but the site was being moved (not Dos_Box's fault but the poor instructions onscreen). I don't have a spare cable and I don't want to buy another because the new version of this card has a different connector - the cables are £30!!! I have borrowed a different card off Dos_Box now and will test it all again tomorrow.
Ric_ Posted December 1, 2006 Author Posted December 1, 2006 The card I have borrowed off Dos_Box seems to have allowed me to see the tape library again Looks like my card is goosed so I will have to shell out for a new one Best get counting the pennies!
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now