HP ProCurve Network Config - New DHCP Scope and Default Gateway

[CHiLL]

I've been looking into Always-On VPN from Microsoft and started to implement it for testing. I'm looking at networking section and it recommends having a DHCP scope set up for VPN clients. I have created the scope, set the pool and set the default gateway address. Now...I have no network config set up for this traffic and I've gotten a bit stuck. So I have the following:

 

VPN server with 2x NIC; 1x 10.22.0.x on our DMZ and 1x 10.22.11.0 on our server VLAN. Route created between the NICs.

Certificate server configured as per Microsoft's documentation.

NPS server configured as per Microsoft's documentation.

Firewall rules created to our DMZ IP

Internet DNS created to our Internet facing VPN URL

DHCP range set up for; 10.22.220.x/24 with 10.22.220.1 as the default gateway and 10.22.220.2-254 as client addresses.

 

We have a HP ProCurve 5406Rzl2.

 

1) How do I create a default gateway, so that our authenticated clients on the VPN DHCP scope can talk to the rest of our site and access their home folder, shared drives, etc?

2) Do I need to VLAN this traffic off? If so, what commands are needed for this?

 

Thanks!

Edited December 8, 2017 by CHiLL