Netgear NMS100 ProSafe Network Management Software

[Ben_Stanton]

Lets say I have 20 AP's. With this software, can I distribute a common 'theme' saving individual loborious configuration of each seperate access point?

 

Thanks in advance...

 

Ben

[psycho98]

Hi Ben as the netear NMS100 is a managed device. All you have to do is configure the NMS so that is is viewable on your network then plug in your APs and then run the scan for devices it should then pick up the APS. If it does not you can do an ip scan.

 

Once all APs have been connected you ten can setup a profile on the managed system and then the APs will then sync theirselves and down load the new profile from the managed device.

 

Hope this helps