Procurve Connectivity issues
We repalced our core switch over half term. The old core swith (HP 4108GL) was relocated to replace an old HP 8000m switch. We have a connectivity issue between the newly located 4108 and a HP2524 switch.
They are connected via Fibre optics with the same transceiver module at both ends. The link light on both ends of the connection are up and and cant see any confiuration issues which raise any alarms.
The one think which I believe to be the cause is that the 2524 is shown as being connected to a different port on the 4108. Its shown on port to which it used to be connected when the 4108 was in our comms room.
Is there a way to flush the mac table so that the switch can learn the new location. I am not very familiar with HP OS commands. I cant seem to find a clear mac-address table command .
I understand that most people advice against flushing the mac table but I cant think of what else it could be.