Wireless Network Strangeness
I was wondering if anyone could shed any light on a strange problem we are having.
Most of our wireless network consists of Netgear WG602v2 access points. These have been very unreliable so I've started to replace them with HP Procurve 420 access points. So far I have replaced two.
Most of our laptops work fine with this arrangement. However, we have a number of older laptops which use netgear wireless PCMCIA cards (WG511) to connect to the network. For some reason they always want to connect to the new HP Procurve access points, even when they are in another building!
This screenshot shows the situation quite well. The highlighted access point is the one in the same room which has a strong signal, yet the card chooses to ignore it and connect to the Procurve access point (A4-BD).
If the new access points are switched off then the laptops connect to the strongest signal again, as they are supposed to do!
Anyone got any ideas? The HP Procurve 420 has a lot of settings that I don't understand, but I think I've got it set up correctly.