Ruckus + Smoothwall + guest access - Idiots guide needed
First up I know that there are a few threads on this but I think I have got into a bit of a mess and need some hand holding to get this working.
Basically I just want to set up a simple guest wlan using Ruckus and Smoothwall.
To cut a *very long* story short, I am at the point where the guests can connect to the guest wlan and use their guest pass to auth. Clients get an IP, can use DNS and if I manually configure the proxy (or enable auto detect settings after auth) they can browse Internet. However I want it to be as hands off as possible.
- I have it from Ruckus support that there is no way that guest clients can use non-transparent proxies without configuring each device so I need to set up a transparent filter on my SW box.
- A nice chap from SW set this up and said I needed to route all the guest traffic through the SW box to be filtered. I think that this is where I am lost now. How to I do this?
- Oh and we don't have any vlans.
I will sit here banging my head on the desk until someone can come help