Desperate for help Ruckus controller restarted after changing management VLAN
I spent the last two days logging the MAC addresses, IP addresses and Port Numbers that all our our 36 active Ruckus access points are joined to in order to complete the work started last summer. I had everything working but on the default VLAN, VLAN1. The AP's were on VLAN 1 and so was the Ruckus 3000 Controller. I followed the help instructions and configured the access points to VLAN 8 which is the IP address range I want my clients to be issued an address in. I entered 8 in the Management VLAN in "Access Point Policies" and I entered 8 in configure system/device IP settings for the controller as well. After restarting the controller I cannot ping it at all.
I have every port that the AP's are plugged into untagged on the default VLAN (1) and tagged on VLAN 8 (WIFI). The Zone Director was untagged in VLAN1 and Tagged in VLAN 8.
I cannot ping on the fixed address assigned to the controller. I even tried changing the port to untagged on the default VLAN and restarting the box.
I took my fluke tester and connected it directly to the Zone Controller whilst disconnected from the network and I got no IP address.
Foolishly it dod not even occur to me to back up the config because I did not expect there to be a problem.
Can anyone help - I'm holiday tomorrow and have to have it for lessons on Monday!