I have 2 of the c-Class GbE2c Switches in my C3000 blade enclosure and one of them is working fine but i am now experiencing some issues where the one isnt providing enough bandwidth for all the servers so i am going to utilise the second one and configure port trunking but i cant get the ports to enable on the second switch!! I have tried via telnet into the console and also via the web browser but i get the following error:
"ERROR: Server Port 1 cannot be enabled because of a mismatch"
I have updated the firmware on this switch to 2.0.60 from 2.0.50 to see if it helped but it didnt.
I cant offer much advice as I cant remeber how ours were setup (plus I'm not near it atm)
Are you configuring it through web interface or through telnet? Do your On-Board Administrator(s) detect both switches correctly?
There are currently 1 users browsing this thread. (0 members and 1 guests)