pls help in configuring vlan in procurve
Hi, all... i have liitle issue in configuring vlan in procurve 2510.. Please could help me in this... Thanks in advance.... :-)
i am configuring two ports port 5 to vlan 21 and port 6 to vlan 27, and port 12 for trunk in pro curve layer 2 switch 2510g... and in h3c layer 3 switch i have configured these two vlans and enabled port 45 gigabit port as trunk.. but i am not able to ping from one system to another... i usually worked in cisco router that too while learning and in packet tracer.. so hp is new to me.. please help me yaar..
the procedure i followed some of them i will show here pls see.
in pro curve:
(eth-5)#vlan 21 untagged ethernet 5
(eth-6)#vlan 27 untagged ethernet 6
(config)# trunk ethernet 12 trk1
[user]interface Vlan-interface 21
[user]interface Vlan-interface 27
[user-Vlan-interface21]ip address 21.1 255.255.255.0
[user-Vlan-interface21]ip address 27.1 255.255.255.0
and i have enabled trunk encapsulation and allowed all vlans... pls help me out... what i am doing io dont know.. may in commands confgn is there anything more in need to do.. pls..