Wired Networks Thread, Got a procurve problem... in Technical; One of our 5406zl procurves is indicating a POE fault on PSU1,
Initially we checked that in the firmware POE ...
8th August 2012, 11:05 AM #1
Got a procurve problem...
One of our 5406zl procurves is indicating a POE fault on PSU1,
Initially we checked that in the firmware POE is enabled for the port we want to use, but no volts appear. I've had a look at logs and there is nothing in them. On the management interface the PS icon indicating the power supply is red, that is the only indication of a fault on the unit. There is no fault light on, on the back of the switch.
I guess my question here is:
Is there anything else I can try?
Should I reboot before I call HP and risk the switch not coming back up?
Should I just call HP and get an advance replacement?
IDG Tech News
8th August 2012, 11:20 AM #2
Try reseating PSU1. It might just be loose, or oxidised connectors.
Thanks to Geoff from:
Oaktech (8th August 2012)
8th August 2012, 11:40 AM #3
Good thought... I think i'm going to get an advance replacement before I turn it off. I've only got one PSU in this switch.
8th August 2012, 12:09 PM #4
Have multiple ports stopped getting PoE? Or just the one? There's a chance if the above doesn't fix it that one of the rails has died in the PSU if it's mutiple ports. If it's just the one port, the module with the port might have a fault, rather than the PSU. Do you graph any switch snmp info with Cacti or Nagios? Errors will show up there too..
By fracmo2000 in forum Wired Networks
Last Post: 30th September 2011, 02:40 PM
By denon101 in forum Windows
Last Post: 1st February 2011, 02:35 PM
Last Post: 30th July 2008, 03:34 PM
By crc-ict in forum Windows
Last Post: 21st July 2006, 05:21 PM
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)