Add drivers to existing 2008 installation
I've restored a working installation of Server 2008 R2 (that was installed on a single disk sata system) to the same server but on a RAID1 enabled disk system (its an HP DL120 G6 using the onboard RAID)
Problem is now the server blue screens at the boot stage - which I guess is due to the new raid array needing a driver. I have the correct driver but is there any way I can add this to my installation of Server 2008? I can't even boot it into safe mode so is there any other way I can do this? I've tried the Startup repair but that doesn't do anything - it does detect the drive array after I add the drivers so proves the drivers are working.
All I want to do is add the drivers to the server installation so it will boot up - even safe mode would be a start!