Office Software Thread, how to change the data values in excel in Technical; OK, so there i was all proud of myself for sorting out conditional formating for my little analysis sheet, then ...
14th September 2012, 12:16 PM #1
how to change the data values in excel
OK, so there i was all proud of myself for sorting out conditional formating for my little analysis sheet, then i come up with a problem.
The data sheet is comparing expected levels from last year to what they actually achieved (Green for above expected, Yellow expected, red below expected). But after putting the data in i noticed a little issue, the levels were coming up wrong.
We are a special school so the values are in Pscales or low NC levels:
but the Plevels are being read as higher that the NC levels and the NC levels are being read in the wrong order, i.e order is 1C, 1B, 1A, 2C, etc...... But 1c is coming out as higher than 1a etc-- I suppose due to alphabetical order.
Any ideas on help.
It would be much appreciated
IDG Tech News
By pooley in forum How do you do....it?
Last Post: 19th March 2013, 10:01 AM
By lionsl2005 in forum Virtual Learning Platforms
Last Post: 5th April 2011, 12:42 PM
By albertwt in forum How do you do....it?
Last Post: 2nd March 2011, 12:01 PM
By MattMitchell in forum MIS Systems
Last Post: 22nd March 2010, 01:24 PM
By mattx in forum General Chat
Last Post: 15th February 2009, 10:05 AM
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)