You may also need to refer to this thread:
Server 2008 WDS not working on new vlan
You may need an extra setting or 2 added to your DHCP server to make PXE boots possible
What error you getting when you try to PXE?
May need to double check your WDS Setup is correct
I press F12 to boot from LAN, and it get this, then it goes back to select boot device screen
Interl(R) Boot Agent GE v1.3.66
Copyright (C) 1997-2010, Intel Corp
Client MAC Addr: F0 DE F1 99 72 C6 GUID: 81F1D9AE AA51 CD11 B3A0 8E5CCB381DF1
Client IP: 172.18.68.24 MASK: 255.255.252.0 DHCP IP: 10.20.1.10
GATEWAY IP: 172.18.68.1
PXE-M0F: Exiting Intel Boot Agent
Looking at those IP's, you eaither have multiple domains or VLAN's in place (the DHCP server has a different range). My link above has the fix for that
Is DHCP on the same server as WDS? If so you need to tick the 2 boxes under the DHCP tab on your WDS server's properties
EDIT: Or it could be what he said!! Lol
We have this machine in a different vlan for testing. Im no network engineer, but we currently have KACE up and running, but trying to get away from it. It pxe boots just fine, so i thin there is some setting my network buddy has to fix.
which means DHCP probably isn't (assuming you will have checked! )
network guy is going to check the settings from that link
"On your DHCP server, set the following 2 Server Options (not scope options):
Option 66 - set the IP address of the WDS server
Option 67 - boot\x86\wdsnbp.com
I had the same problem when I changed over in February"
Ah yeah - I have a similar entry for SCCM
We got PXE booting working... but i get this error now:
A connection to the deployment share \\imaging\deploymentshareT420s$ could not be made. The following networking device did not have a driver installed PCI\
Im assuming i should add Out of Box network driver to the deployment share, then hit update?
Yeah I'd add it to your boot image, along with any Mass storage devices (eg Sata [Raid] Drivers) as MDT / WDS tend to shout a bit if they aren't present...
updating image now... let's see what happens.
So i loaded the driver as out of box driver, and then updated the deployment. It said injecting drivers etc... then finished. I then went into WDS and "Replaced Image" the boot image with the new LiteTouch_x64.wim... but it still errors out with the network card driver device ... oj hwait it wotrk now!
Ok, well i created the task sequence to deploy, but it errored out
ERROR - Unable to find SETUP needed to install the image?
I should prob try with a fresh Deployment
There are currently 1 users browsing this thread. (0 members and 1 guests)