Cisco IOS ACL - port range?

[localzuk]

Is it possible to set up an ACL on a cisco switch which covers a range of ports (eg. 30015-30215)?

I can do individual ports easily enough, but I don't want to have to do 200 ports...

[alttab]

Is it possible to set up an ACL on a cisco switch which covers a range of ports (eg. 30015-30215)?

I can do individual ports easily enough, but I don't want to have to do 200 ports...

have a look at the int range command. should put a range of interfaces (either vlan, gigE, FE) from within config mode. if you have a range of none contiguous ports you may be able to use a comma to specify all the different ports you want to apply acl to in one command (although have not had a reason to use that before so don't know how well the latter works)

[localzuk]

have a look at the int range command. should put a range of interfaces (either vlan, gigE, FE) from within config mode. if you have a range of none contiguous ports you may be able to use a comma to specify all the different ports you want to apply acl to in one command (although have not had a reason to use that before so don't know how well the latter works)

I'm referring to TCP/UDP ports, rather than physical ports. The int range command refers to physical ports.

[alttab]

I'm referring to TCP/UDP ports, rather than physical ports. The int range command refers to physical ports.

sorry, i read it as you wanting to apply an acl(s) to a range of interfaces. thought it sounded a bit strange needing to apply ip acl's to 200 switch ports. should have read your first post properly.

[cpjitservices]

This page may help you.

Configuring Commonly Used IP ACLs - Cisco Systems

I love ACL's

[nicholab]

Just stick "range 30015-30215" instead of "eq 30015"