Network and Classroom Management Thread, CC3 - Network Drives not mapping in Technical; Hi,
I have just added an RM Ready workstation on a CC3 network, it has finished building however it is ...
4th December 2008, 12:14 PM #1
CC3 - Network Drives not mapping
I have just added an RM Ready workstation on a CC3 network, it has finished building however it is not mapping the drives, it says preparing connection when it oads up and has a connection as I can go Start - Run to get to the network, the mapped drives just won't show up.
When building this workstation it complained that the NETbios was incorrect however I knew it was, I changed it slightly I added a .Internal to it and then it went through but then all of a sudden came up that it stopped responding and needed to close, pressing don't send and then restarted and built fine.
Any ideas why the drives won't map?
IDG Tech News
4th December 2008, 12:21 PM #2
The NetBIOS should be DOMAIN
The UPN Suffix should be DOMAIN.internal
4th December 2008, 12:22 PM #3
I've not got a clue why it won't map the drives, but I very rarely build direct from a CC3 ready workstation. I always do a full build even on new machines.
4th December 2008, 04:01 PM #4
Ok I have it sorted.
I have been having a few embarrasing D'oh moments the past couple of weeks haha, I was logging in as just Administrator rather than systemadmin...
The drives are all mapped when logging on with any network account.
Sorry but thanks for your posts.
By Chuckster in forum Scripts
Last Post: 21st August 2008, 05:27 PM
By Pyroman in forum How do you do....it?
Last Post: 11th June 2008, 04:19 PM
By FN-GM in forum Scripts
Last Post: 7th May 2008, 03:00 PM
Last Post: 14th November 2007, 06:42 PM
By mac_shinobi in forum Scripts
Last Post: 8th March 2007, 04:49 PM
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)