Digital signage vga senders
We had a digital signage solution installed for us from a company who we later fell out with due to differences of opinion.
The TV's are still up though as they were purchased so I thought I would have another go at getting them to display. The pc that used to run the display software had motherboard failure but I think there may have been a power spike which took it out.
I have XIBO set up on a server here and a display pc connected to a vga splitter which is in turn connected to 3 vga over ethernet senders. It appears that these are doing nothing as no signal is being picked up at the other end.
Does anyone know of an easy way to test these? I have checked the network cable runs and there is not problem with them but I'm not sure how to check the senders/receivers. I tried taking them out and putting them between a pc and a monitor but I get a no signal response. Does this mean they are duff?
What would you suggest replacing them with?
I would really like to get these going again as they were good while they lasted and it was the easiest way to get messages around the school.