Configuring Netgear WG302 via command line
I'm trying to reconfigure a Netgear WG302v1 WAP after a move of location and have pushed the reset button on the back of the device to reset this to factory settings but cannot browse to this device via web browser. I have configured the locally attached laptop to be on the same default IP/Subnet range, Firewalls are disabled & Proxy servers are not confugured but still i am unable to contact the WAP.
I am now trying via HyperTerminal and have found that the subnet has been set to 0.0.0.0 which i'm sure isn't default setting so am trying to change this but am not sure what command i should be using I've tried "set system gateway :255.255.255.000" but this just returns "system gateway : 0.0.0.0". I've tried a mix of this command but don't seem to be getting anywhere. Any help would be great thanks