Hardware Thread, RJ11/12 socket to RJ45 plug adapters in Technical; Ok well if you're going from a phone socket then into structured cabling you don't need any of those other ...
17th January 2012, 08:15 PM #16
Ok well if you're going from a phone socket then into structured cabling you don't need any of those other adaptors you really just need to convert to cat5.
I did it by, take cable with bt phone plug on and punch down onto cat5 module this then convert the bt socket to cat5 capable. Then this was patched over the structured cabling and at the other end you just need to do rj11/12 to rj45, simplest to replace the cable on the phone.
IDG Tech News
17th January 2012, 09:05 PM #17
The phone lines will be going into a FreePBX box at some point though.
17th January 2012, 09:16 PM #18
You only need one set of capacitors and surge aresstors though so if keeping the bt socket that's fine.
In the future with the free pbx then the cabling will still go from pbx to socket of straight of cat5 to phone?
17th January 2012, 09:23 PM #19
I imagine I'll use SIP phone on desks, so I wont need to patch phone lines anywhere.
17th January 2012, 09:30 PM #20
Ok no worries in case just need to do what I said.
18th January 2012, 11:40 AM #21
Thanks to Gaz from:
Geoff (18th January 2012)
18th January 2012, 02:13 PM #22
Thats the ones!
18th January 2012, 02:16 PM #23
Arh, they're called Line Adapter Units ("LAU" is what I searched for)
18th January 2012, 02:18 PM #24
The CPC pages helpfully explain the differences too.
PSTN - - mastered with surge arrestor
Secondary - - no mastering or surge arrestor
PABX - - mastered without surge arrestor
By ranj in forum Hardware
Last Post: 10th October 2011, 09:21 AM
By enjay in forum Hardware
Last Post: 26th May 2011, 10:29 AM
By Carter in forum General Chat
Last Post: 17th November 2010, 12:44 PM
By SYNACK in forum Hardware
Last Post: 2nd September 2010, 01:48 PM
By CSNM-Carl in forum General Chat
Last Post: 1st June 2010, 10:07 AM
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)