Mounting a Casio laser projector to Promethean Sanyo mount

[plexer]

Just replaced a dead sanyo xe-30 with a casio XJ-A130 and thought I'd share how I mounted it with you.

Attached is a picture of the modified sanyo original mount.

Basically I cut off all the sticky out bits with a hacksaw, flipped it over and then marked the holes for the casio with a paper template, with the casion mounted using 3mm screws you can then use some washers and the original mounting bolts to attach it to the original mount.

Ben

[john]

Done a similar thing with other Sanyo mounts from Promethean, except in once case I just mounted a piece of MDF to the base of the metalwork, saved a bit of hassle and cutting the metal

[glennda]

Hiya,

Is this one the these

We have a few of these and are trying to replace the projector

Toby

[plexer]

Done a similar thing with other Sanyo mounts from Promethean, except in once case I just mounted a piece of MDF to the base of the metalwork, saved a bit of hassle and cutting the metal

Yeah I considered that or using a piece of laser cut polycarbonate, I'm going to look at a slightly adjustable version and crack the welder out once it's powder coated should be fine.

Hiya,

Is this one the these

We have a few of these and are trying to replace the projector

Toby

Toby: No it's not one of the all in one units but a ceiling mounted XE-30, I doubt even the casio provides enough range for that close use, however could you measure the distance from the front of the lens to the surface of the board and also the size of the board you have please?

Thanks.

Ben

[glennda]

Nah I didn't think it did either - we have just had to replace them with expensive £1000 Santos as they are the only ones that would fit!

[PEO]

sahara universal mount no more than £60

[PEO]

sahara universal mount - Google Product Search

[mylittlereddress]

You could also have a look at this mount from Comproom Limited - was cheap when bought with the projector.
Comproom Limited: Projector Upgrades and Replacements