Switch rack mounting brackets

[Oops_my_bad]

Stupid question, but does anyone know where I can get hold of the mounting brackets for switches? As we've had a few gone missing over the years.I've tried the manufacturers and ebay, also they aren't standard mountings across manufacturers

[localzuk]

You'd have to either speak to the manufacturer of that particular device, or speak to a fabrication company to make some for you.

[FN-GM]

I think i have some cisco ones if they are handy?

[Oops_my_bad]

Thanks chaps

Zak - the screw holes are different on the Cisco ones and I'm using netgears, thanks anyway

I might ask the D+T chaps to see if they can knock any up, then again they can't even cut wood straight so...

[steve]

How about sitting them in the cabinet on some vented shelves:

Linky

[FN-GM]

Thanks chaps

Zak - the screw holes are different on the Cisco ones and I'm using netgears, thanks anyway

I might ask the D+T chaps to see if they can knock any up, then again they can't even cut wood straight so...

Ah well never mind. I will keep my eyes open though.

Z

[Oops_my_bad]

How about sitting them in the cabinet on some vented shelves:

Linky

Good call i didn't know you could get these, certainly worth a look

[sjatkn]

Try these FSMS400 for £17.60 from Comms Express. http://www.comms-express.com/pd1940017343.htm?defaultVariants=search0_EQ_Grey_A ND_{EOL}&categoryId=130

They do 1/2/3U varieties with different depths.

[Heebeejeebee]

I once had some knocked up by the CDT department. Worked a treat.

I have a stock of old ones from ditched switches but only one set of Netgear ones and I'd like to keep hold of those just in case I end up in the same situation as you .

HBJB

[ChrisH]

If you get stuck just use a 1U shelf.

[john]

Thin aluminimum sheet and tin snips, snip snip snip bend around the edge of a desk, drill some holes and some screws inserted into them voilla, new rack mount bracket.