Hardware Thread, USB Not Recognised in Technical; Morning,
I have a new Fujitsu M290 which for some reason has messed up its USB settings and won't recognise ...
21st November 2012, 11:06 AM #1
USB Not Recognised
I have a new Fujitsu M290 which for some reason has messed up its USB settings and won't recognise any USB hard drives installed.
I have done the old, remove all USB devices from the hardware manager and rebooted but it still doesn't work. Strangly after doing this the little MS USB Bluetooth device has shown lots of unknown devices listed with a couple of crosses on which weren't there before.
I have tried the USB in another PC of the same model and its fine.
Is this a reinstall do you think?
Its a Intel chipset which won't reinstall.. when I run the installer it doesn't go into the installer and what I have read says you can't uninstall these.
I've removed all the USB devices also after rebooting also. The driver that is used on the working pc lives on the non workign one also..
Anyone seen this before? Usually uninstalling the USB works for me but this one is a bugger.... oh and its got the latest BIOS
21st November 2012, 11:19 AM #2
Did it extract to a folder, should have inf files you can right click (unless you've tried this [not the installer]?).
Originally Posted by Simcfc73
21st November 2012, 08:17 PM #3
Check the registry HKLM\System\MountedDevices
Delete all the \??\Volumexxxx entries and reboot.
Does it start to work again?
21st November 2012, 08:36 PM #4
- Rep Power
Hello, connect the USB drive and look in disk management, diskmgmt.msc then try and change it's auto assigned letter.
By bewlay51 in forum Hardware
Last Post: 12th February 2010, 06:52 PM
By macfab in forum Hardware
Last Post: 25th November 2009, 12:21 PM
By lionsl2005 in forum How do you do....it?
Last Post: 27th January 2009, 09:22 AM
By Gerry in forum Hardware
Last Post: 16th January 2009, 01:32 PM
By enjay in forum Hardware
Last Post: 16th November 2007, 03:26 PM
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)