Writing in a straight line on a smart board
We have a smart board at our school that has an issue when writing on it. The teacher displays a paper with missing lines. When filling in the lines it works fine until you get to the center of the board and then the writing starts to sag about a half inch below where the pen contact is. Once you pass that point it is fine again. does anyone think changing to a fine 20 point orient will fix this or is the board bad.
writing in a straight line
I have been thru all of that I had that problem with another board. I did use the 20 point calibration and got the issue reduced to an area in the upper right corner about 3" wide by 5" long. It has at least made the board useable again for the teacher. Our tech department is getting a control board to use as a tester. We will see if that does anything.
Originally Posted by synaesthesia