General Chat Thread, VGA over ethernet or similar in General; what about a Slingbox and Slingcatcher?...
24th October 2008, 04:31 PM #16
- Rep Power
what about a Slingbox and Slingcatcher?
24th October 2008, 11:00 PM #17
You should be able to run a cable through the buildings where the fibre exists? There must be a pipe between the two to carry the fibre, there should be a pull through left in the pipe.
Otherwise, what about running VGA to a wifi video sender and then reciever at the other end to take the VGA onwards? Obviously this depends on the range of the video sender and the distance between the building. I can't think of the company off the top of my head, but i know wireless VGA senders are fairly common. I've used them quite a few times in sitiuations where projectors are in ridiculous places and we didn't want to cable the VGA to a wall, so we just had a sender with a male D plug on it. That went straight into the laptop VGA socket, of anyones laptop and the projecter had the reciever on the other end. I've done distances of about 200m but it was probably only travelling through air of an average humidity. I don't know what it would be like outside, through walls, or in the winter when the humidty increases and the air becomes denser.
I'm going round in circles now in my head, but if i think of anything else i'll post again.
24th October 2008, 11:21 PM #18
you could try this lot:
Manufacturers of Video Switches, Routers and Extenders.
We use smart-e stuff for exactly this one box vga to rj45 into a multiple output transmitter then back to vga at both screens
Hope this helps
15th September 2009, 03:38 PM #19
please help me I have same problem too
I need VGA signal from PC(which is in building 1) to monitor (wich is in building 2)
but between this bildings is ~20 km (10-12 mile)
it is fiber cable support between this buildings
Last edited by shota; 15th September 2009 at 03:41 PM.
15th September 2009, 03:54 PM #20
15th September 2009, 04:25 PM #21
It is not remote desktop with two PCs or something like this
15th September 2009, 04:29 PM #22
- Rep Power
This may work but i have not tried it
Cat5 VGA sender to fibre media convertor - other building fibre media convertor to cat5 vga receiver.
for the above it would cost around £150, but it may not work (in theory it should).
15th September 2009, 04:51 PM #23
WBS its likes good maybe I'll try it thnx
15th September 2009, 06:56 PM #24
that won't work as most simple cat5 vga baluns don't convert the signal to an ip stream just send the analog signal over the cable.
16th September 2009, 01:18 PM #25
Do you know any manual link how to send the analog signal over the cable?
By Samson in forum Wireless Networks
Last Post: 20th June 2007, 10:02 AM
By sidewinder in forum Windows
Last Post: 8th June 2007, 08:43 PM
By sqdge in forum Wireless Networks
Last Post: 5th April 2007, 04:09 PM
By stevegwernyfed14 in forum Web Development
Last Post: 24th February 2006, 10:07 AM
By ChrisH in forum Hardware
Last Post: 3rd February 2006, 12:29 PM
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Tags for this Thread