+ Post New Thread
Page 2 of 2 FirstFirst 12
Results 16 to 25 of 25
General Chat Thread, VGA over ethernet or similar in General; what about a Slingbox and Slingcatcher?...
  1. #16

    Join Date
    Feb 2007
    Location
    Devon
    Posts
    40
    Thank Post
    4
    Thanked 2 Times in 2 Posts
    Rep Power
    16
    what about a Slingbox and Slingcatcher?

  2. #17

    Join Date
    Jun 2007
    Location
    Wakefield, West Yorkshire
    Posts
    621
    Thank Post
    95
    Thanked 129 Times in 100 Posts
    Rep Power
    66
    You should be able to run a cable through the buildings where the fibre exists? There must be a pipe between the two to carry the fibre, there should be a pull through left in the pipe.

    Otherwise, what about running VGA to a wifi video sender and then reciever at the other end to take the VGA onwards? Obviously this depends on the range of the video sender and the distance between the building. I can't think of the company off the top of my head, but i know wireless VGA senders are fairly common. I've used them quite a few times in sitiuations where projectors are in ridiculous places and we didn't want to cable the VGA to a wall, so we just had a sender with a male D plug on it. That went straight into the laptop VGA socket, of anyones laptop and the projecter had the reciever on the other end. I've done distances of about 200m but it was probably only travelling through air of an average humidity. I don't know what it would be like outside, through walls, or in the winter when the humidty increases and the air becomes denser.
    I'm going round in circles now in my head, but if i think of anything else i'll post again.

  3. #18
    djdohboy's Avatar
    Join Date
    Aug 2008
    Location
    Watford, Hertfordshire
    Posts
    55
    Thank Post
    0
    Thanked 7 Times in 6 Posts
    Rep Power
    14
    you could try this lot:

    Manufacturers of Video Switches, Routers and Extenders.

    We use smart-e stuff for exactly this one box vga to rj45 into a multiple output transmitter then back to vga at both screens

    Hope this helps

  4. #19
    shota's Avatar
    Join Date
    Sep 2009
    Posts
    4
    Thank Post
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    Hello all
    please help me I have same problem too
    I need VGA signal from PC(which is in building 1) to monitor (wich is in building 2)
    but between this bildings is ~20 km (10-12 mile)
    it is fiber cable support between this buildings

    any idea?

    thnx
    Last edited by shota; 15th September 2009 at 03:41 PM.

  5. #20
    Dom_'s Avatar
    Join Date
    Dec 2008
    Posts
    1,009
    Thank Post
    151
    Thanked 138 Times in 115 Posts
    Rep Power
    56
    Logmein pro? :-)

  6. #21
    shota's Avatar
    Join Date
    Sep 2009
    Posts
    4
    Thank Post
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    It is not remote desktop with two PCs or something like this

  7. #22
    WBS
    WBS is offline

    Join Date
    Sep 2009
    Location
    lancashire
    Posts
    1
    Thank Post
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    This may work but i have not tried it

    Cat5 VGA sender to fibre media convertor - other building fibre media convertor to cat5 vga receiver.

    for the above it would cost around 150, but it may not work (in theory it should).

  8. #23
    shota's Avatar
    Join Date
    Sep 2009
    Posts
    4
    Thank Post
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    WBS its likes good maybe I'll try it thnx

  9. #24

    plexer's Avatar
    Join Date
    Dec 2005
    Location
    Norfolk
    Posts
    13,328
    Thank Post
    622
    Thanked 1,577 Times in 1,414 Posts
    Rep Power
    413
    that won't work as most simple cat5 vga baluns don't convert the signal to an ip stream just send the analog signal over the cable.

  10. #25
    shota's Avatar
    Join Date
    Sep 2009
    Posts
    4
    Thank Post
    0
    Thanked 0 Times in 0 Posts
    Rep Power
    0
    Do you know any manual link how to send the analog signal over the cable?

SHARE:
+ Post New Thread
Page 2 of 2 FirstFirst 12

Similar Threads

  1. LAN VoIP or similar
    By Samson in forum Wireless Networks
    Replies: 5
    Last Post: 20th June 2007, 10:02 AM
  2. Replies: 1
    Last Post: 8th June 2007, 08:43 PM
  3. Ethernet PCI Card
    By sqdge in forum Wireless Networks
    Replies: 8
    Last Post: 5th April 2007, 04:09 PM
  4. RM Easylink - need to achive similar... how?
    By stevegwernyfed14 in forum Web Development
    Replies: 33
    Last Post: 24th February 2006, 10:07 AM
  5. Replies: 11
    Last Post: 3rd February 2006, 12:29 PM

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •