Enterprise Software Thread, SCCM 2012 pxe problems in Technical; Help! I'm pulling my hair out here and have spent the last 10 days trying to get it to work. ...
25th April 2012, 09:18 PM #1
- Rep Power
SCCM 2012 pxe problems
Help! I'm pulling my hair out here and have spent the last 10 days trying to get it to work. Followed Windowsnoob tuturials.
I installed SCCM 2012 RTM on a dedicated server 2008R2 and I cant get PXE to work. DHCP installed on a seperate server.
Added DHCP 66 ip address of SCCM/PXE DHCP 67 \smsboot\x86\wdsnbp.com
Tried adding IP Helper on Cisco switches
PXE loads an IP address from DHCP boots WDSNBP but reports no response from Windows Deployment Services Server it then gives me the option to press F12 when i press this it shows errors as below
WDSNBP started using DHCP Referral.
Contacting Server: 172.16.0.3 (Gateway: 0.0.0.0)...
No response from Windows Deployment Services server.
Press F12 for network service boot
If I press F12, I receive a Windows Boot Manager error message
Windows failed to start (etc.)
Info: An error occurred while attempting to read the boot configuration data.
Virtual pints on offer for anyone who can help me out on this one.
IDG Tech News
18th May 2012, 09:53 AM #2
- Rep Power
Can't help out with a solution but I'm having the same problem in my newly setup lab environment. Did you ever find a solution to this problem?
18th May 2012, 10:03 AM #3
- Rep Power
See all comments on another thread with a similiar issue- http://www.edugeek.net/forums/o-s-de...-pxe-boot.html
"I had the same issue on my first attempt of sccm
2012 and spent nearly 2 weeks trying to get it working, i then reformatted and started again and briefly had the same issue but found articles surrounding the below helpful.
Check your boot folders are populated in SMSBOOT\x86 and x64 if not search for articles on this also there are occasions were the c:\windows\temp\bootimages folder gets corrupted or incorrect permissions lots of articles to search for on this.
I had to create a new WINPE boot disk from waik
using the Deployment Tools Command Prompt then import it into SCCM
Also even if you are not using 64bit you must create both it seems "
18th May 2012, 10:41 AM #4
Try taking the leading \ out..
Originally Posted by AliG
eg just use
This is how its config'd on my 2007 setup...
By Athlona in forum Enterprise Software
Last Post: 19th April 2012, 03:00 PM
By pete in forum Enterprise Software
Last Post: 7th June 2011, 02:17 PM
By adamf in forum O/S Deployment
Last Post: 21st February 2011, 03:48 PM
By danboid in forum O/S Deployment
Last Post: 18th August 2009, 02:58 PM
By f21970 in forum O/S Deployment
Last Post: 4th August 2009, 01:47 PM
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)