+ Post New Thread
Results 1 to 3 of 3
AV and Multimedia Related Thread, Faulty Hitachi ED-X10 in Technical; @ Marc-Engineer Just had a look at a faulty ED-X10. I just pulled the power and reset the processor on ...
  1. #1

    plexer's Avatar
    Join Date
    Dec 2005
    Location
    Norfolk
    Posts
    13,691
    Thank Post
    756
    Thanked 1,715 Times in 1,526 Posts
    Rep Power
    438

    Faulty Hitachi ED-X10

    @Marc-Engineer

    Just had a look at a faulty ED-X10.

    I just pulled the power and reset the processor on it to start with.

    When it turns on you can see the ocasional flcker of light through the lens and then it shuts down with the lamp led illuminated in red.

    Is this just a failed bulb that can't strike fully?

    Ben

  2. #2

    Join Date
    Dec 2007
    Location
    Grimsby Lincs
    Posts
    314
    Thank Post
    0
    Thanked 53 Times in 38 Posts
    Rep Power
    39
    Sounds like it, how many hours has it on the lamp? or has it been knocked when on? this would distort the lamp (the lamp is actually the thin tube in the center of the reflector) if it is distorted its life is very very reduced.

    Marc
    Projector Engineer

  3. #3

    plexer's Avatar
    Join Date
    Dec 2005
    Location
    Norfolk
    Posts
    13,691
    Thank Post
    756
    Thanked 1,715 Times in 1,526 Posts
    Rep Power
    438
    It's ceiling mounted so hasn't been knocked so I would think it's just new bulb time then.

    Thanks.

    Ben



SHARE:
+ Post New Thread

Similar Threads

  1. Replies: 2
    Last Post: 26th November 2009, 07:31 PM
  2. Hitachi ED-X10 Lamp Reset
    By plexer in forum Hardware
    Replies: 8
    Last Post: 27th October 2009, 01:03 PM
  3. Hitachi ED-X3280 Filter
    By laserblazer in forum Hardware
    Replies: 4
    Last Post: 24th September 2009, 01:21 PM
  4. Hitachi ED-A100 Ultra-short throw
    By psydii in forum Hardware
    Replies: 7
    Last Post: 12th March 2009, 01:28 PM
  5. Hitachi ED-X32 Projector - recommendations?
    By bertster in forum Hardware
    Replies: 1
    Last Post: 24th November 2008, 02:44 PM

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •